Ignition System – Ignition Switches, Conserving Battery Energy
Starting up the car will automatically activate the ignition system to start firing up thousands of voltage into the spark plugs. But before a vehicle starts, it is vital to prepare the engine for operation. Thus, the employment of an ignition switch is a necessity. This auto component is where the key is inserted, making it possible for the engine to start. Preparing the engine for a timely operation is also one task of the ignition switch. However, its main function is to control the flow of electricity, helping the battery conserve much of its energy, in effect.
Tags: Battery, Conserving, Energy, Ignition, ignition switch, ignition system, Switches
Related posts
Ignition system – How To Set A Vehicle’s Ignition Timing
Setting your ignition timing is very easy. First you must locate the timing scale; this is located beside the crankshaft pulley. The “T” or the “0″ represents Top Dead Center (TDC). This place is scaled in 1 or 2 degree increments, and you should have the correct timing marked for your vehicle. If not, you will have to count to the right degrees. You can find that on a label printed somewhere on the vehicle under the hood.
It is always helpful to have a pen and pad ready to write these down before hand so you do not have to keep going back and forth. You must then locate the notch on the balance or the crankshaft pulley and mark it with something that will be visible under the timing light. You then need to start your engine and let it warm up to the normal operating temperature. Once it has warmed up, you must shut your vehicle down by turning off all the lights and any other electrical loads. Read the rest of this entry »
Tags: Ignition, ignition system, Timing, VehiclesRelated posts
Ignition system – Automobile ignition key and Prevention four rules – the reasons for car ignition, car ignition prevention – Fire Industry
“Spontaneous combustion” of the fuse
Fuel leak can be said to cause Auto ignition Important reasons, some ordinary car on the carburetor, fuel filter installed in the engine compartment and more, and from the engine block and the distributor close to, if oil leakage occurs, the mixture reaches a certain concentration, coupled with fire occur, spontaneous combustion Accident Is inevitable, while in summer high temperature, fuel filter connection tubing due to heat deformation temperature is low, making the original connection is very tight hose heat loose, leading to gas leak.
Second, transmission oil and power steering oil leaking into the hot exhaust pipe on the car ignition is triggered the “conspiracy.” In the absence of any sign of the case, the car burst of spontaneous combustion is mostly an accident caused by circuit failure. Fault lines in the spontaneous combustion due to accident, blame it on the line is to blame man-made random changes.
In addition, the car uses long life Power supply The aging, prone to short-circuit, causing spontaneous combustion fire; car long-distance running, overload loading, so that all parts of the engine stop in the long run, resulting in temperature, combined with hot weather, the engine Ventilation Equipment is not good, cause power line short circuit, causing spontaneous combustion fire; Car Improper placement of goods between Collision , Sparks, spontaneous combustion caused by fire vehicles. Read the rest of this entry »
Tags: auto ignition, Automobile, Fire, four, Ignite, Ignition, ignition inc, ignition switch, ignition system, ignition wire, Industry, Prevention, reasons, rules